Electronics Mixers Adapters

The CS-4 is an 4 Channel automatic microphone mixer. Full feature design includes : Daisy-chain with unlimited numbers of the mixer. Three operation modes: one-channel-at-a time, all active or override. Switchable inputs accept microphones or line level devices .Switchable output levels between mic. and line level. Individual gain control and phantom power for each channel. Last In stays on for continuous ambience sound. Control voltage provided to trigger external device such as speaker switching and camera switching

The CS-8 is an 8 Channel automatic microphone mixer. Full feature design includes : Daisy-chain with unlimited numbers of the mixer. Three operation modes: one-channel-at-a time, all active or override. Switchable inputs accept microphones or line level devices .Switchable output levels between mic and line level. Individual gain control and phantom power for each channel. Last In stays on for continuous ambience sound.Control voltage provided to trigger external device such as speaker switching and camera switching

1m Extension cable to connect and cascade CS-1 & CS-8 Mixers

The MA-123 provides -10dB, -20dB or -30dB attenuation to prevent overload of sensitive input stages. Full metal case optimizes shielding to reduce hum. Designed for balanced low-Z microphones. Passes phantom power.

The MA-250K Matches a low-impedance microphone to a high-impedance input. This allows use of long microphone cables. Maintains high-frequency response. Reduces noise pickup. Provides 21dB of voltage gain. Input Connector: XLR-Female. Input Impedance: 250? Output Connector: 6.3 TS Jack plug. Output Impedance: 50K?

The MA-500 is a clever little adaptor that allows you to connect a standard 3 pin XLR from an input with phantom power to a JTS 4 pin mini XLR condenser microphone. PAD (-10dB) and Low Cut (100Hz -6dB 400Hz -4dB) switches. Can be powered by JTSÂ’s PS-1, Phantom Power Supply or 48V phantom power from other devices.

The MA-HPF is a very useful adaptor featuring an XLR (Female) input and on the other end an XLR (Male) output. This High pass filter is designed for 150 Ohm rated microphones and inputs. Perfect to reduce unwanted noise at low end in the microphone signal. Provides low cut of 12dB per octave below 100Hz. Slender, in-line design. Full metal case optimizes shielding to reduce hum. Passes through phantom power from the input.

The MA-PRS Provides instant selection of normal or reversed phase of a balanced line without modification of equipment. A switch reverses polarity of pins 2 and 3 in a balanced line. Slender, in-line design with XLR (Female) to XLR (Male) configuration and may be used in reverse. Full metal case optimizes shielding to reduce hum.

The MA-SW is a Microphone Adaptor Switch. This inline adaptor switch is symetrical. Being symentrical it can work in either direction. For use with dynamic microphones. If used with microphones with phantom power please note this switch does not switch of the phantom power.

This very handy XLR-USB adaptor allows dynamic or condenser microphones to be digitally recordeded. This excellent solution allows the user to plug headphone directly into the adapter and, with volume controls, balance the volume between the microphone and playback audio. UIsing this method irradicates the problem of latency between the source and the playback.

A standard female XLR to a 4 pin mini XLR cable. Ideal for connecting the output of PS-500/PS-510M to a body pack transmitter

48v Phantom Power Supply for condenser microphones where Phantom Power is absent from mixer

Available in single or dual versions.

Our handy JTS PS-500 is a 9V battery operated phantom power supply with two mini XLR(M) inputs and one XLR(M) output. It works as a mini mixer for JTS CX and CM series condenser microphones with volume controls for input channels 1 & 2. A Mic/Line switch also allows mixing of Line signals.

Our handy JTS PS-510M offers the facilities of the PS-500 with a 9V battery operated phantom power supply with two mini XLR(M) inputs and one XLR(M) output but also adds a headphone monitor output in order that the musician can here the mix before sending to the PA.

Wireless handheld microphone for WA-35

The PMM-4 is ideal as a compact personal monitor mixer for meeting rooms, Houses of Worship, broadcast and educational public address systems. Four inputs with XLR 1/4” phone jack combo connecter. It has two additional auxiliary inputs and four XLR split outputs.

The WA-35 is a Portable MP, FM amplifier system with wireless microphone. integrated 14.8 V rechargable powered. Ideally suited for outdoor applications such as travel guides , public announcements due to its splashproof housing, MP3 playback via USB interface and SD card slot. FM radio with 20 station presets .Wireless 16-channel microphone system in the licence-free range 863-865 MHz. Alarm siren: 2-tone and wailing sound. LED lamp with continuous light, automatic SOS light and automatic flashing light.